Entering System Mode - VeriFone P200 Reference Manual

Entering System
Mode
NOTE
Accessing System
Mode
NOTE
With an application loaded, use the following procedure to enter System Mode.
Before entering System Mode and selecting the function(s) to perform, verify that
the unit has been installed as described in P400/P400 Plus Installation Guide,
VPN - DOC435-003-EN or P200/P200 Plus Installation Guide, VPN -
DOC430-003-EN. Make sure that the unit is connected to a power source and is
turned on.
To enter System Mode:
1
Press the '1', '5', '9' keys at the same time.
2
Select preferred login.
Figure 5 System Mode Login Screen
•
Supervisor: Full capability
•
Level 1: User defined capability
•
Level 2: User defined capability
•
Maintenance: Intended for Verifone repair, allows minimal access
A special menu can be accessed by pressing the Cancel key — Reboot, Run
Apps, Transfer Logs, and System Info can be accessed without logging in or
entering any password.
3
Once the login has been selected, enter the password. If the password is pre-
expired or is pending change the user must enter the current password and
then a new password (pre-defined in the case of a pending password change).
The new password must be entered twice for validation. The default System
Mode password is:166831.
Users (Prod)
supervisor
level1
level2
maintenance
P200/P400 R
S M
YSTEM ODE

Entering System Mode

21
G
EFERENCE UIDE