Ddl Command Line File; Ddl Example; Downloading Without An Onboard Application; Network Download Utility - VeriFone P200 Reference Manual

DDL Command Line
File

DDL Example

Downloading
without an Onboard
Application
Network Download
Utility
Features
[config-data]
If you need to specify more variables than what the DOS command line allows,
you can use a simple configuration file (-F option) to extend the length of the
command line. A command line file is an ASCII text file that allows you to supply
as many variables as required.
Download the file app.tgz using the PC's COM port 2 (app.tgz is a binary file).
DDL -p2 -iapp.tgz
Each line in the command line file should consist of one variable:
-p2 app.tgz
The command line would be:
DDL -F<filename>
Use the following procedure to perform a download from a host PC to an P200 or
P400 PINpad with no application installed. The PINpad must be powered on to
begin the procedure.
1
Make all cable connections.
2
Launch the DDL application on the host PC.
3
Enter System mode using a secure password.
4
Tap Update panel on the main System mode menu.
5
Tap Serial panel tab to perform direct download to the PINpad.
6
Select the COM Port (COM1).
7
Select Baud Rate to start download process.
Asterisks (*) display on screen to indicate the state of the download. Each asterisk
denotes approximately 10% completion. On download completion, the PINpad
returns to the main screen.
Network Download transfers files from a PC to the PINpad. A network download
client, included with the SDK, must be installed onto a PC. Before the file transfer
can begin, the network settings must be configured and then the transfer starts by
tapping the "Netloader" under Transfer.
Description
Specifies PINpad or application environment variables. If the
specified variable exists, it is replaced by the new value;
otherwise, a new entry is created.
For example, the string *ZR=TERMID sets the value of the
PINpad identifier variable to "TERMID".
To remove an existing entry, use an empty string.
Note:
For example, *ZT= " " removes the *ZT variable.
P D
ERFORMING OWNLOADS
Download Methods and Procedures
P200/P400 R G
EFERENCE UIDE
49