Advertisement
•
If you experience difficulty with the system
recognizing a command, try saying it more softly, and
wait for a few seconds after the beep, or you may just
try saying it again.
•
Background noise may cause voice commands to be
misunderstood, including airflow noise from wind.
•
To use the voice recognition system, the map DVD
must be loaded.
This system is able to recognize commands in three
different languages. The system will only recognize
commands based on the language selected from the
Driver Information Center (DIC). See "Driver Information
Center, DIC Vehicle Personalization" in the Index of
your vehicles owner manual.
Voice Recognition Commands
The following list shows all of the voice commands
available for the navigation system with a brief
description of each. The commands are listed with the
optional words in brackets. To use the voice commands,
refer to the instructions listed previously.
Voice Tag Commands
The following are voice tag commands you can access
by clearly stating the commands exactly as they are
written. You may have up to 40 voice tag entries for
destinations.
Navigation go to [destination] (voice tag), navigation
select [destination] (voice tag): These commands
instruct the system to select a destination saved under
the voice tag you have stored.
When a destination is requested using a voice tag, the
system will state, "Press or say cancel if not correct".
To cancel this voice tag destination, using voice
recognition, push and hold the
control until you hear a beep, then say "cancel".
If you are not currently driving on a route, the system
will automatically create the voice tag destination as the
final destination. If you are currently driving on a
route, the system will automatically create the voice tag
destination as a waypoint. Up to three waypoints can
be created.
g
(talk) steering wheel
4-3
Advertisement
