Samsung AR7000 Manual page 43

1. Extend the assembly cable if necessary.
2 . Open the cover panel.
3 . Remove the screw securing the connector cover.
4 . Pass the assembly cable through the rear of the indoor unit and connect the assembly cable to terminals.
(Refer to the picture below)
5 . Pass the other end of the cable through the 2.56inch(65mm) hole in the wall.
6 . Close the connector cover by tightening the screw carefully.
7 . Close the cover panel.
8 . Remove the terminal board cover on the side of the outdoor unit.
9. Connect the cables to the terminals as seen in the picture.
L1 L2 F1 F2
L1 L2 F 1 F 2
F 1 F 2
L1 L2
10. Connect the grounding conductor to the grounding terminals.
11. Close the terminal board cover by tightening the screw carefully.
English-43
AR7000 CV HP_IB&IM_DB68-05637A-00_EN.indd 43 2015/10/16 10:33:09