Table of Contents
Advertisement
1886
1
Turning off the power
Ensure the power is OFF at the outlet box
and wall switch location before proceeding
with installation.
2
Installing the battery
To access the battery compartment, slide the
battery door up.
Replace the used battery with two AAA
batteries when needed. Clean the battery
contacts prior to installing the batteries.
Please contact your local battery recycling
center for proper battery disposal information.
3
Wiring the Wall Control
Connect the grounding wire from the wall
control to the ground control from the
switch box using the provided wire nuts.
Connect the "LIVE IN" from the switch
box to the "~VAC" from the wall control
using the provided wire nuts.
Connect the "LIVE OUT" from the switch
box to the "FAN" out from the wall control
using the provided wire nuts.
Push all wires into the switch box.
4
Installing the Wall Control
Install the longer screws through the
slots in the wall control into the switch
box screw holes.
5
Installing the Wall Plate
Install the shorter screws through the
wall control plate and into the screw
holes in the wall control.
6
Turning on the power
9
Ceiling Bracket
Preparing the Wall Control
Battery
Door
ON
ON
Hanging Fan
Wiring
OFF
OFF
7
8
Canopy
Blades
KEY PRESS
LIGHT FUNCTIONS
Long
Press
Long
Press
Long
+
Press
FAN FUNCTIONS
Long
Press
Long
Press
Long
Press
Long
+
Press
The remote transmitter is already paired to the
receiver and ready to use. If you need to pair
your remote, cycle power to the fan by turning
power off and back on at the wall switch (or
circuit breaker if necessary). Within three
minutes, do the following:
Reference the included remote function
card for information on how to use your
wall control!
NOTICE
• Always purchase the correct size and grade of
battery most suitable for the intended use.
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the
device prior to battery installation.
• Ensure the batteries are installed correctly with
regard to polarity (+ and -).
• Remove batteries from equipment which is not to
be used for an extended period of time.
• Remove used batteries promptly.
Light
Glass/Bulbs
FUNCTION
Light On/Off
Light Dimming
Control
Light High
Light Low
Dimming Mode
On/Off
Fan On/Off
Fan Speed
Control
Fan High
Fan Low
Reverse
Power On/Off
Pair Function
Wall Control
Advertisement
Table of Contents
