Table of Contents
Advertisement
Before first use
1. Make sure that the set level of the water
softener agrees with the water hardness in
your area. If not, adjust the water softener.
Contact your local water authority to know
the water hardness in your area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
Adjusting the water softener
German
degrees
(°dH)
> 24
18- 24
12- 18
4 - 12
< 4
1) Factory position.
2) Do not use salt at this level.
Electronic adjustment
1. Press the on/off button to activate the appli-
ance. Make sure that the appliance is in set-
ting mode. Refer to 'SETTING AND START-
ING A PROGRAMME'.
2. Press and hold function buttons (B) and (C)
at the same time until the indicators above
function buttons (A), (B) and (C) start to
flash.
3. Press function button (A).
• The indicators above function buttons (B)
and (C) go off.
• The indicator above function button (A)
continues to flash.
• The display shows the current setting of
the water softener, e.g.
4. Press function button (A) again and again to
change the setting.
5. Deactivate the appliance to confirm the set-
ting.
www.zanussi.com
4. Open the water tap.
5. Processing residues can stay in the appli-
Water hardness
French
degrees
(°fH)
> 40
32 - 40
19 - 32
7 - 19
< 7
Filing the salt container
= level 5.
ance. Start a programme to remove them.
Do not use detergent and do not load the
baskets.
mmol/l
degrees
> 4.2
3.2 - 4.2
2.1 - 3.2
0.7 - 2.1
< 0.7
1
Electronic
Clarke
adjust-
ment
28
5
22 - 28
4
13 - 22
1)
3
5 - 13
2
< 5
2)
1
2
5
Advertisement
Table of Contents
