Table of Contents
Advertisement
A
3
Fill the detergent dis-
penser (A) with deter-
gent.
A
5
Using the combi detergent tablets
When you use tablets, that contain salt and
rinse aid, do not fill the salt container and the
rinse aid dispenser.
1. Adjust the water softener to the lowest level.
2. Set the rinse aid dispenser to the lowest po-
sition.
If you stop to use the combi detergent
tablets, before you start to use separately
detergent, rinse aid and dishwasher salt,
do these steps:
1. Press the on/off button to activate the appli-
ance.
2. Set the water softener to the highest level.
3. Make sure that the salt container and the
rinse aid dispenser are full.
4. Start the shortest programme with a rinsing
phase, without detergent and without
dishes.
www.zanussi.com
B
4
If you use a washing
programme with pre-
wash phase, put more
detergent in the pre-
wash detergent com-
partment (B).
6
5. Adjust the water softener to the water hard-
ness in your area.
6. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to ac-
cept some operations.
The appliance is in setting mode when, after the
activation:
• All the programme indicators are on.
If the control panel shows other conditions,
press and hold function buttons (B) and (C) at
the same time until the appliance is in setting
mode.
Starting a programme without delay start
1. Open the water tap.
2. To set a programme, keep the appliance
door ajar.
3. Press the on/off button to activate the appli-
ance.
4. Make sure that the appliance is in setting
mode.
5. Press the button of the programme you
want to set.
• The programme duration flashes in the
display.
• The related programme indicator comes
on.
• The wash indicator comes on.
6. Close the appliance door. The programme
starts.
• The display shows the programme dura-
tion that decreases with steps of 1 mi-
nute.
• The wash indicator stays on.
Starting a programme with delay start
1. Set the programme.
2. Press the delay button again and again until
the display shows the delay time you want
to set (from 1 to 19 hours).
• The delay time flashes in the display.
• The delay indicator comes on.
7
Advertisement
Table of Contents
