Table of Contents
Advertisement
Problem
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
After the checks are completed, activate the ap-
pliance. The programme continues from the
point of interruption.
If the problem occurs again, contact the Serv-
ice.
If other alarm codes appear, contact the Serv-
ice.
If the washing and drying results are not
satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a lower
position.
• The quantity of detergent is too much.
Technical information
Dimensions
Electrical connection
Water supply pressure
1)
Water supply
Capacity
www.zanussi.com
Make sure that the mains plug is connected to the mains
socket.
Make sure that there is not a damaged fuse in the fuse box.
Make sure that the appliance door is closed.
If the delay start is set, cancel the setting or wait for the end
of the countdown.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Close the water tap and contact the Service.
Stains and dry water drops on glasses and
dishes
• The released quantity of rinse aid is not suffi-
• The quality of the detergent can be the
Dishes are wet
• The programme is without a drying phase or
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
Cold water or hot water
Place settings
Possible solution
cient. Adjust the rinse aid selector to a higher
position.
cause.
with a low temperature drying phase.
Refer to 'HINTS AND TIPS' for other pos-
sible causes.
2)
545 / 447 / 480
220 - 240 V
50 Hz
(0.8 / 0.08 ) / (10 / 1.0 )
max. 60 °C
6
11
Advertisement
Table of Contents
