Technical Information - Zanussi ZDT 16011 User Manual

Problem
The dishes are wet and matt.
Activating the rinse aid dispenser with the multitab
function activated
1. Press the on/off button to activate the appliance.
2. Make sure that the appliance is in setting mode. Refer
to 'SETTING AND STARTING A PROGRAMME'.
3. Press and hold function buttons (B) and (C) at the
same time until the indicators of function buttons (A),
(B) and (C) flash.
4. Press function button (B).
• The indicators of function buttons (A) and (C) go
off.
• The indicator of function button (B) continues to
flash.

Technical information

Dimensions
Electrical connection
Water supply pressure
1)
Water supply
Capacity
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy), use the hot water supply to decrease
energy consumption.
26
Possible cause
The rinse aid dispenser is empty.
The quality of the rinse aid can be the
cause.
The quality of the combi detergent tab-
lets can be the cause.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
Cold water or hot water
Place settings
Make sure that there is rinse aid in the
rinse aid dispenser.
Try a different brand of rinse aid.
• Try a different brand of combi deter-
gent tablets.
• Activate the rinse aid dispenser and
use the rinse aid together with the
combi detergent tablets.
• The display shows the setting of the rinse aid dis-
penser.
5. Press function button (B) to change the setting.
6. Deactivate the appliance to confirm.
7. Adjust the released quantity of rinse aid.
8. Fill the rinse aid dispenser.
2)
Possible solution
Off
On
596 / 818 - 898 / 550
220-240 V
50 Hz
(0.5 / 0.05 ) / (8 / 0.8 )
max. 60 °C
12