Identification Of Parts; Setting Time And Date - Olympus VN-750 Instructions Manual

Identification of parts

1
2
3
4
5
6
7
8
9
1 Built-in microphone
2 MIC (Microphone) jack
3 POWER switch
4 Recording indicator light (LED)
5 STOP (4) button
6 ERASE button
7 0 button
8 `OK button
9 MODE button
0 EAR (Earphone) jack
! Display (LCD panel)
@ REC (s) (Record) button
# + button
$ 9 button
% DISPLAY button
^ – button
& Built-in speaker
4
EN
Turning on the power
Slide the POWER switch to the [ON]
position.
0
ON
!
@
#
$
%
OFF
^
&
Turning off the power:
While the recorder is in stop mode,
slide the POWER switch to the [OFF/
HOLD] position.
Power save mode:
If the recorder is on and stops for 5
minutes or longer, the display shuts
off and it goes into power save mode.
To exit power save mode, press any
button.
HOLD:
If you slide the POWER switch to the
[OFF/HOLD] position, the current
conditions will be preserved, and all
buttons will be disabled.

Setting time and date

If you set the time and date
beforehand, the information will be
stored automatically when the file
is recorded. This function enables
easier file management.
" When you install batteries
for the first time or each time
you replace the batteries, the
"hour" indicator will flash.
When the "hour" is flashing,
conduct the setup from step 1.
1 Press the + or − button to change
the setting.
2 Press the `OK or 9 button to
set.
• Repeat step 1 and 2 to set
"minute", "year", "month" and
"day". After the "day" has been
set, the recorder's clock will start
working.
• You can select between 12 and
24 hours display by pressing the
DISPLAY button while setting
the hour and minute.
Example: 10:38 P.M
• You can select the order of the
"month", "day" and "year" by
pressing the DISPLAY button
while setting them.
Example: March 24, 2011
3 Press the 9 or 0 button to
set the beep sound.