Table of Contents
Advertisement
•
Fold the baseplate towards the machine.
•
Attach the cable clip.
•
Fasten the baseplate on the housing with the three fastening screws.
•
Attach the face plate.
•
Attach connection plugs 2 and 3 onto the circuit board of the front housing shell.
•
Install the sewing lamp cable.
•
Mount the facing panel of the front housing panel.
•
Insert the housing insert and fasten with the torx screws.
•
Attach the top cover.
The following points must be checked and adjusted:
•
Section 19 „Adjustment of bobbin thread tension"
•
Section 20 „Adjustment of needle thread tension"
•
Section 22 „Adjustment of equal forward and reverse stitch length"
65
- Quick Links:
- Dismantling the Housing
Hide quick links:
Advertisement
Table of Contents
