Sony DVP-NS3100ES Service Manual page 64

DVP-NS3100ES
Pin No. Pin Name
46 OUTSW
47 DGND
48 VDD18
49, 50 PD (6), PD (5)
51 DSPCLK
52 DSPDAT
53 DSPSTRB
54, 55 PD (1), PD (0)
56 VSS
57 VDD33
58 OUT-ERR
59 OUT-EVALID
60 VSS
61 OUT-CLK
62 VDD18
63 OUT-DVALID
64 OUT-DATA
65 OUT-SYNC
66 SCL
67 SDA
68, 69 PE (3), PE (2)
70 SPDIR
71 IRQ_FE
72 VSS
73 VDD33
74 PF (1)
75 DSPSTRB2
76 VSS
77 VDD18
78 PG (1)
79 PG (0)
80 TEST
81 RESET-N
82 VSSADC
83 VDD18ADC
84 GNDPLL
85 CKOUT
86 FREOUT
87 FREIN
88 VCC18PLL
89 LD1
90 LD2
91 VCCA33
92 TWINSEL
93, 94 LMD1, LMD2
64
I/O
Disc tray open detection signal input terminal "H": Disc tray is closedFixed at
I
"H" in this set
- Ground terminal (digital system)
- Power supply terminal (+1.8V) (digital system)
O Internal signal monitor output terminal Not used
O Internal signal monitor output terminal Not used
O Internal signal monitor output terminal Not used
O Internal signal monitor output terminal Not used
O Internal PDM signal monitor output terminal Not used
- Ground terminal (digital system)
- Power supply terminal (+3.3V) (digital system)
O Error signal output to the CPU
O Word clock signal output to the CPU
- Ground terminal (digital system)
O Bit clock signal output to the CPU
- Power supply terminal (+1.8V) (digital system)
O PCLK signal output to the CPU
O Serial audio/video data output to the CPU
O Error signal and V4 signal output to the CPU
I I2C bus clock signal input from the CPU
I2C two-way data bus with the CPU, interlace/progressive converter and video
I/O
decoder
- Not used
Spindle motor rotation direction detection signal input from spindle motor driver
I
"L": reverse direction, "H": forward direction
O Interrupt request signal output to the CPU
- Ground terminal (digital system)
- Power supply terminal (+3.3V) (digital system)
O Internal signal monitor output terminal Not used
O Internal signal monitor output terminal Not used
- Ground terminal (digital system)
- Power supply terminal (+1.8V) (digital system)
Boot mode selection mode signal input terminal "L": standalone mode,
I
"H": EMU modeFixed at "L" in this set
Boot mode selection mode signal input terminal "H": standalone/EMU mode
I
Fixed at "H" in this set
I Input terminal for the test
I Reset signal input from the CPU "L": reset
- Ground terminal (analog system)
- Power supply terminal (+1.8V) (analog system)
- Ground terminal (analog system)
- Not used
- Not used
I 27 MHz clock signal input from clock generator
- Power supply terminal (+1.8V) (analog system)
O Laser diode control signal (for DVD) output terminal
O Laser diode control signal (for CD) output terminal
- Power supply terminal (+3.3V) (analog system)
I Connected to the ground
I Laser diode monitor input from the optical traverse unit
Description