Sony DVP-NS3100ES Service Manual page 15

1-5. DVD Dual Layer Disc (Opposite)
Note: Make sure, using the TDV-540C in this adjustment.
Select [5], insert DVD dual layer disc (TDV-540C), and press
[ENTER] key, and the adjustment will be made through the following
steps, then adjusted values will be written to the flash memory. If
there is no disc on the disc tray, the tray will be open to wait for
closing. If there is a disc on the disc tray, the adjustment starts
immediately. If you put a disc prior to adjustment, confirm that the
DL disc is set on the disc tray.
DVD Dual Layer Disc Adjustment Steps
1. Sled Reset
2. Set Disc Type DL
3. Laser Diode (DVD) ON
4. Focus Error Check
5. Focus ON
6. Spindle Start
7. Tracking Error Level Adjust
8. Tracking Error Offset Adjust
9. Tracking ON
10. RF Level Adjustment
11. Spindle Calibration
12. Tracking Off
13. Tracking Error Level Adjust 2nd
14. Tracking Error Offset Adjust 2nd
15. Tracking ON
16. Auto Focus Gain Adjust L0
17. Auto Tacking Gain Adjust L0
18. Sled ON
19. CLV ON
20. Auto Focus Balance Adjust L0
21. Auto RFEQ Boost Adjust L0
22. Jitter measure
23. Search Check
24. Focus Jump (L0 t L1)
25. Tracking Off
26. Tracking Error Level Adjust
27. Tracking Error Offset Adjust
28. Tracking ON
29. Auto Focus Gain Adjust L1
30. Auto Tracking Gain Adjust L1
31. Sled ON
32. CLV ON
33. Auto Focus Balance Adjust L1
34. Auto RFEQ Boost Adjust L1
35. Search Check
36. All Servo Off
2. Drive Manual Operation
On the Test Mode Menu screen, select [2], and the manual operation
menu will be displayed. For the manual operation, each servo on/
off control and adjustment can be executed manually.
## Drive Manual Operation ##
2. Operation Commands
3. Servo Control
4. Track/Layer Jump
6. Memory Check
7. Changer Manual Move
8. Changer Mecha Check
Model :DVP-NS3100ES
Revision:xxx xxx
Basic operation (controllable from front panel or remote
commander)
: Power OFF
I/1
: Servo stop
x
: Stop+Eject/Loading
Z
(RETURN) : Return to Operation Menu or Test Mode Menu
O
, : Transition between sub modes of menu
> .
[1] to [9], [0]
: Selection of menu and items
Cursor [Q]/[q] : Increase/Decrease in manually adjusted value
2-2. Operation Commands
### Drive Manual Operation ###
2. Operation Commands
1. Search Disc (DVD Priority)
2. Search Disc (CD Priority)
3. PLAY
4. Pause
5. Stop
[1] Serch Disc : DVD SDISC (F/E command) is performed by
(DVD Priority) priority.
[2] Serch Disc : CD SDISC (F/E command) is performed by
(CD Priority) priority.
[3] PLAY
: Playback the current disc (DVD/CD).
Start address is DVD = 0x030000 or CD =
00:02:00.
[4] Pause
: Pause
[5] Stop
: Stop
Note: After Search Disc, hold on in 10 seconds.
DVP-NS3100ES
Exit: RETURN
Exit: RETURN
15