Table of Contents
Advertisement
oFF:
1-rP – 4-rP:
1-St – 4-St:
End:
SV-1 Ramp Target Value: Sets the target value for each ramp
to
to
segment.
SV-4 Setting range: 0-100% of full scale
TM1r Ramp Segment Time: Sets the duration of each ramp
to
to
segment.
TM4r Setting range: 00.00 to 99hrs 59mins.
TM1S Soak Segment Time: Sets the duration of each soak
to
to
segment.
TM4S Setting range: 00.00 to 99hrs 59mins.
Mod Ramp/Soak Mode: Up to 16 different modes of ramp/soak
operations are possible. Choose the appropriate code
from the Table of Ramp/Soak Modes
Setting: 0-15
FACTORY PRESET MENU
P-n1
Control Action & Sensor Burn-out Protection: The
Control Action is the direction of the output relative to
the process variable. The controller can be programmed
as either a reverse-acting or a direct-acting controller.
In a reverse-acting controller, the controller's output
decreases as the process variable increases. A heating
Not in operation
Executing 1st – 4th ramp
Executing 1st – 4th soak
End of program
57
Advertisement
Table of Contents
