System Board; Removing The System Board - Dell OptiPlex Small Form Factor 7010 Owner's Manual

Steps
1. Using a screwdriver, remove the HDMI module cover from the chassis.
NOTE: This step is applicable only when the HDMI module is being installed for the first time.
2. Connect the HDMI-module cable to the connector (VIDEO) on the system board.
3. Insert the HDMI module into the slot on the chassis.
4. Replace the two (M3x3) screws that secure the HDMI module to the chassis.
Next steps
1. Install the side cover.
2. Follow the procedure in

System board

Removing the system board

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch hard drive
5. Remove the 3.5-inch hard drive
94 Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
if applicable.
if applicable.
computer.
computer.