Steps
1. Place the processor fan and heat-sink assembly on the system board and align the captive screws to the screw holes on the
system board.
2. Tighten the four captive screws that secure the heat stink to the system board.
3. Connect the processor-fan cable to the connector on the system board.
Next steps
1. Install the
disk-drive
cage.
2. Install the
3.5-inch hard drive
3. Install the
2.5-inch hard drive
4. Install the
front
bezel.
5. Install the
side
cover.
6. Follow the procedure in
Processor
Removing the processor fan and heat-sink assembly
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
front
bezel.
4. Remove the
2.5-inch hard drive
5. Remove the
3.5-inch hard drive
6. Remove the
disk-drive
7. Remove the
processor fan and heat-sink
78
Removing and installing Field Replaceable Units (FRUs)
if applicable.
if applicable.
After working inside your
Before working inside your
if applicable.
if applicable.
cage.
assembly.
computer.
computer.