Optical Drive; Removing The Optical Drive - Dell OptiPlex Small Form Factor 7010 Owner's Manual

Steps
1. Place the disk-drive cage upside down on the chassis.
2. If the optical drive is installed, connect the data and power cable to the connectors on the optical drive.
3. Hold the disk-drive cage upright and align the mounting points on the disk-drive cage with the slots on the chassis.
4. Align the screw hole on the cage with the screw hole on the chassis.
5. Install the single (6-32) screw to secure the disk-drive cage in place.
6. If the optical drive is installed, route the power and data cables through the routing guide on the disk-drive cage.
Next steps
1. Install the 3.5-inch hard drive
2. Install the 2.5-inch hard drive
3. Install the front bezel.
4. Install the side cover.
5. Follow the procedure in

Optical drive

Removing the optical drive

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch hard drive
5. Remove the 3.5-inch hard drive
6. Remove the disk-drive
if applicable.
if applicable.
After working inside your
Before working inside your
if applicable.
if applicable.
cage.
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs) 51