Dell OptiPlex Small Form Factor 7010 Owner's Manual page 91
Hide thumbs
Also See for OptiPlex Small Form Factor 7010:
- Owner's manual (119 pages) ,
- Owner's manual (119 pages) ,
- Owner's manual (119 pages)
Table of Contents
Advertisement
Steps
1. Remove the two (M3x3) screws that secure the DP module to the chassis.
2. Disconnect the DP-module cable from the connector on the system board.
3. Lift the DP module off the system board.
Installing the DP module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the DP module and provides a visual representation of the installation procedure.
Removing and installing Field Replaceable Units (FRUs)
91
Hide quick links:
Advertisement
Table of Contents
