Remington MB4040 Manual page 5

• If hair builds up in the trimmer comb during the trimming process, switch the unit off,
pull off the comb and brush/rinse off
,To define the beard/moustache line
• Hold trimmer with Trimmer Blade facing you.
• Remove the trimmer comb attachment
• Start with edge of beard/moustache line and gently lower the trimmer blade onto your
skin. Use motions towards edge of beard/moustache line to trim to desired locations in
facial area and away from beard in neck area.
• For trimming in tight spots or small areas attach Detail Trimmer Blade.
, Creating The Stubble Look
• The attachment comb should be on and set to position 1 (1.5mm) or 2 (2.5mm) and
Stubble Trimmer Blade should be attached.
• Trim hairs using and upward or downward motion against or with the direction of hair
growth, whichever is preferred.
• For an even closer "stubble look" remove the adjustable comb and repeat the above
step.
C BLADE RELEASE
• Remove the adjustable comb.
• Push the release button on the front of the product.
• Blade will release itself from its housing.
• Remove the blade from the housing.
• To replace the blade, make sure the blade is aligned and the grooves on the blade
cartridge match up with slots in the housings.
• Push the blade into the housing until it snaps into place.
C REPLACING THE TRIMMER COMB
• Hold the trimmer in one hand with your thumb firmly on the zoom wheel to keep it from
turning. Ensure that the length position indicator is at 1.
• Slide the comb/shaver down the grooves until it clicks into place.
Note: The trimmer comb attachment can only be placed on the trimmer one way; if it
does not fit properly remove and reverse it.
ETips for best results
• Beard, moustache and sideburn hairs should be dry.
• Avoid using lotions before using your trimmer. Comb your hair in the direction that it
grows.
• Remove trimmer comb attachment if you are: defining hairline edges such as sideburns,
trimming the nape of your neck, trimming your beard line on front of neck.
5