CAME VLR01DX Installation Manual page 37

Function description
Immediate closing activation/
deactivation.
By default, this function is deactivated.
Ti can only be used if the batteries
are installed.
KLT transmitters memory storing*.
The buttons programming is automatic:
▲ = open;
= stop;
▼ = close;
pressed for 5 seconds = partial
opening.
Memorizing the weather stations*.
Each weather station occupies the
memory space of 3 transmitters.
CAME transmitters memorizing*
- With Rolling Code transmitters (TAM
and TOP), the buttons programming is
automatic:
button 1 = opens;
button 2 = closes;
button 3 = stops (four-channel only);
button 2 = partial opening (four-channel
only).
- With fi xed code transmitters (TOP),
any memorized button will execute
commands in sequence (open, stop,
close, stop).
Radio cancellation.
All memorized transmitters and control
units will be deleted.
Restore factory settings.
It returns all parameters to the default
value. Transmitters and weather stations
remain stored.
* For the radio-control of the automation, it is possible to store up to 25 codes, between transmitters and meteo-control stations.
At the end of programming, return the DIP to the default status (all OFF).
How to program it
Hoe to arrange the
DIPs
1 2 3 4
OFF ON ON ON PROG on the card.
ON OFF OFF OFF PROG on the card.
Within 10 seconds press
one of the buttons on the
transmitter to be memorized.
If the transmitter has previously been memorized, the LED flashes
quickly and the buzzer beeps 4 times.
OFF ON OFF OFF PROG on the card.
Within ten seconds press the
P2 key on the weather station.
If the weather station is already memorized, the LED will fl ash
quickly and the buzzer beeps 4 times.
ON ON OFF OFF PROG on the card.
Within 10 seconds press
one of the buttons on the
transmitter to be memorized.
If the transmitter is already memorized, the LED flashes quickly and
the buzzer beeps 4 times.
OFF OFF ON OFF Press PROG on the card for 5
seconds.
ON ON ON ON PROG on the card.
→ 1 beep = activation
2 beeps = deactivation
→ The red LED flashes.
→ Once memorized, the buzzer
emits a beep.
→ The red LED flashes.
→ Once memorized, the buzzer
emits a beep.
→ The red LED flashes.
→ Once memorized, the buzzer
emits a beep.
→ After deleting, the red LED
flashes and the buzzer beeps
once.
→ The red LED flashes.
Once the reset is completed the
buzzer beeps twice.