Table of Contents
Advertisement
Installation — Front Mechanical Pointer System
Reference numbers in parentheses in the text refer to
numbers in Parts section of this manual.
Install Bumper Hitch Receiver
(not supplied by Graco)
WARNING
INJURY OR EQUIPMENT DAMAGE HAZARD
D Front receiver mount (not supplied by Graco)
must have minimum rated capacity of 200 lb
(91 kg) tongue weight.
D Read all of this instruction manual before you
use this equipment.
See Fig. 4. Install a single 2 in. x 2 in. hitch receiver
on front of truck. Recommended height for hitch
receiver is 12 to 15 in. (305 to 380 mm) above ground.
NOTES
D Mounting bracket (1) should fit snugly into hitch
receiver. If fit is loose, weight of system could
cause bracket to sag during use, which could result
in poor performance. Select a hitch receiver that
fits, or modify for a good fit. See Fig. 5.
D Before final installation of hitch receiver, check for
adequate clearance in front of truck for mechanical
pointer wheel in stowed position. If stowed wheel
interferes with front of truck, move hitch receiver
forward to increase clearance. See Fig. 6 on
page 7.
hitch receiver
Fig. 4
Fig. 5
Install Front Mechanical Pointer System
Fig. 6 on page 7
Front mechanical pointer system can be connected
with pointer on either side of truck, as shown in Fig. 6.
1. Hitch mounting bracket (1) to hitch receiver with
12 to 15 in.
(305 to 380 mm)
9178A
2. Loosen crossbar frame thumbscrews (20), and
1
proper fit for
level installation
pointer (23) on same side of truck as RoadLazer
striping gun boom arm (A). Remove pin (19)
holding wheel arm in upright stowed position, and
stow pin in hole of crossbar frame (2) with safety
clip in place.
slide crossbar frame (2) out far enough to swing
wheel (18) down to ground.
9238A
309008
5
Advertisement
Table of Contents
