Network; Configuration Menu - Philips Q Line 43BDL3511Q User Manual

43BDL3511Q/50BDL3511Q/55BDL3511Q
Example: 2 x 2 screen matrix (4 displays)
H monitors = 2 displays
V monitors = 2 displays
H monitors
1
3
Example: 5 x 5 screen matrix (25 displays)
H monitors = 5 displays
V monitors = 5 displays
H monitors
1 2
6 7
11 12 13
16 17 18
21 22 23
Frame comp.
Turn the frame compensation function On or Off. If you
select {On}, the display will adjust the image to compensate
for the width of the display bezels in order to accurately
display the image.
Frame comp. Top
Adjust the top frame compensation.
Frame comp. Bottom
Adjust the bottom frame compensation.
Frame comp. Left
Adjust the left frame compensation.
Frame comp. Right
Adjust the right frame compensation.

6.2.5. Network

PICTURE DHCP
SCREEN IP address
AUDIO Netmask
TILING Gateway
Set
NETWORK
CONFIG
OPTION
2
4
3 4 5
8 9 10
14 15
19 20
24 25
Off
. . .
. . .
. . .
DHCP
Select the method to set LAN communication protocol.
{Off} - manual key-in LAN communicaton protocol by user.
{On} - auto configure LAN communicaton protocol.
NOTE: IP address, Netmask and Gateway will gray out when
DHCP is off.
IP address/Netmask/Gateway/Set
Position
Enter the IP address/Netmask/Gateway/Set.

6.2.6. Configuration menu

PICTURE
SCREEN
AUDIO
TILING
NETWORK
CONFIG
OPTION
Position
Switch on state
Select the display status when you connect the power cord
next time.
• {Power off} - The display will remain off when the power
cord is connected to a wall outlet.
• {Forced on} - The display will turn on when the power
cord is connected to a wall outlet.
• {Last status} - The display will return to the previous
power status (on/off/standby) when removing and
replacing the power cord.
Network Control Port
Select RS232 support from
• {RS232} – RS232 come from 2.5mm Phonejack
• {LAN} – RS232 come from RJ45
Boot on source
Select the source when booting up.
WOL
Choose to turn on or off the wake on LAN function.
Choose from : {Off} / { On}.
Light Sensor
Light sensor function is to adjust brightness automatically
when ambient light changed.
Human Sensor
Set the display to turn on backlight if it does sensor human
and turn off backlight after an amount of time specified
The options are: {Off, 10 ~ 60} minutes.
Power LED Light
Select {Off} to turn off the indicator.
OSD turn off
Set the period of time the OSD (on-screen display) menu
stays on the screen.
28
Switch on State
Last status
Network Control Port RS232
Boot on source Last input
WOL Off
Light Sensor
Off
Human Sensor
Off
Power LED light On
OSD Turn Off
OSD Transparent
Information OSD 4 Sec
Logo On
Monitor ID
Monitor Info
Confituration Reset
15
0