Audio; Tiling - Philips Q Line 43BDL3511Q User Manual

Auto adjust
Press "Set" to detect and adjust H position, V position, Clock,
Phase automatically.
NOTE: VGA input only.
Screen reset
Reset all settings in the Screen menu to factory preset values.

6.2.3. Audio

PICTURE Balance
SCREEN Treble
AUDIO Bass

TILING

Volume
NETWORK Audio Out Volume
CONFIG Volume Maximum
OPTION Volume Minimum
Mute
Speaker
Audio Out Sync
Source
Audio reset
Balance
Adjust to emphasize left or right audio output balance.
Treble
Adjust to increase or decrease higher-pitched sounds.
Bass
Adjust to increase or decrease lower-pitched sounds.
Volume
Adjust the volume.
Audio Out Volume
Adjust to increase or decrease the line out audio output
level.
Minimum volume ≤ Volume ≤ Maximum volume
NOTE: This function will be disabled when Audio Out Sync is
ON.
Volume Maximum
Adjust your own limitation for the maximum volume setting.
Volume Minimum
Adjust your own limitation for the minimum volume setting.
Mute
Turn the mute function on/off.
Speaker
Turn the internal speaker on/off.
NOTE: This function is only availavle when "Audio Out Sync"
is on.
Audio Out Sync
Line out volume sync with Volume.
On : Enable the function.
Off : Disable the function and gray out Audio Out Volume.
Source
Select the audio input source.
Analog: audio from audio input.
Digital : audio from HDMI/DVI audio.
Audio reset
Reset all settings in the Audio menu to factory preset values.
6.2.4. Tiling
PICTURE
SCREEN
AUDIO
TILING
0
NETWORK
50
CONFIG
50
OPTION
20
0
100
0
Off
On
Off
With this function you can create a single large-screen matrix
Digital
(video wall) that consists of up to 150 sets of this display (up
to 10-sets on the vertical and 15-sets on the horizontal sides).
This function requires a daisy-chain connection.
Switch on delay
Set the power-on delaying time (in seconds). The default
option {Auto} allows a sequential powering-on for each
display by their ID number when multiple displays are
connected.
The options are:{Off(0) / Auto(1) /2-255}
Brightness: {Normal}/{ACS}
{Normal}: Adjust the overall image and background screen
brightness (backlight).
{ACS}: Automatic Calibration System. The default value
before adjustment is the same as OSD brightness value, e.g.,
70.
Enable
Enable or disable the Tiling function. If {On} is selected, the
display will apply the settings in {H monitors}, {V monitors},
{Position}, and {Frame comp.}.
H monitors
Set the number of displays in horizontal side.
V monitors
Set the number of displays in vertical side.
Position
Set the position of this display in the screen matrix.
27
43BDL3511Q/50BDL3511Q/55BDL3511Q
Switch on Delay
Brightness Normal
Enable
H monitors
V monitors
Position
Frame comp.
Frame comp. Top
Frame comp. Bottom
Frame comp. Left
Frame comp. Right
Auto
Off
1
1
1
Off
3
3
2
1