Table of Contents
Advertisement
● The system may not work properly depending on
the PC or capture board you are using.
For GR-DF570/470 owners:
"USB" appears on the LCD monitor while the
PC is accessing data in the camcorder or the
camcorder is transferring a file to the PC.
NEVER disconnect the USB cable while
"USB" is displayed on the LCD monitor
since this can result in product damage.
* GR-DF570/470 only
Audio Dubbing
The audio track can be customised only when
recorded in the 12-BIT and SP modes.
(
pg. 38)
● Use the provided remote control.
Speaker
START/
STOP
PAUSE
REW
PLAY
STOP
INSERT
A.DUB
1
Play back the tape to locate the point where
editing will start, then press PAUSE (9).
2
While holding A. DUB (D) on the remote
control, press PAUSE (9). The "9D" and "MIC"
indicators appear.
3
Press PLAY (U), then begin "narrating".
Speak into the microphone.
● To pause dubbing, press PAUSE (9).
4
To end Audio Dubbing, press PAUSE (9),
then STOP (8).
Microphone Connector
Stereo Microphone
To hear the dubbed sound during playback
Set "NARRATION" to "ON" or "MIX".
(
pg. 37, 41)
NOTES:
● Sound is not heard from the speaker during Audio
Dubbing.
● When editing onto a tape that was recorded at
12-BIT, the old and new soundtracks are recorded
separately.
● If you dub onto a blank space on the tape, the
sound may be disrupted. Make sure you only edit
recorded areas.
● If feedback or howling occurs during TV playback,
move the camcorder's microphone away from the
TV, or turn down the TV's volume.
● If you change from 12-BIT to 16-BIT in mid-
recording and then use the tape for Audio
Dubbing, it is not effective from the point where
16-BIT recording began.
● During Audio Dubbing, when the tape moves to
scenes recorded in the LP mode, scenes
recorded in 16-BIT audio or a blank portion, Audio
Dubbing stops.
● Audio dubbing is also possible using an optional
microphone connected to the MIC connector.
● While an optional microphone is connected, the
built-in microphone is disabled.
● To perform Audio Dubbing with a video unit
connected to the camcorder's AV connector, first
set "S/AV INPUT" to "ON" in VIDEO Menu.
(
pg. 37, 42)
The "AUX" indication appears instead of "MIC".
EDITING
55
EN
Advertisement
Table of Contents
