Related Manuals for Hyundai HCOMP100-2
Summary of Contents for Hyundai HCOMP100-2
- Page 1 VIBRATORY PLATE HCOMP100-2 WARNING: Read thoroughly the instruction manual before using.
-
Page 2: Table Of Contents
CONTENTS 1. SAFETY INSTRUCTIONS........................... 3 2. THE PRODUCT..............................6 3. ASSEMBLY................................8 4. INSPECTION & OPERATION..........................9 5. MAINTENANCE..............................13 6. STORAGE................................15 7. LIFT AND TRANSPORT............................15 8. TROUBLESHOOTING............................16 9. DECLARATION OF CONFORMITY........................ 17 10. WARRANTY..............................18 11. PRODUCT FAILURE............................19 12. -
Page 3: Safety Instructions
1. SAFETY INSTRUCTIONS 1.1 GENERAL SAFETY RULES a) Understand your Machine Read and understand the operator’s manual and labels affixed to the machine. Learn its application and limitations as well as the specific potential hazards peculiar to it. Be thoroughly familiar with the controls and their proper operation. Know how to stop the machine and ... - Page 4 Keep grounded conductive objects, such as tools, away from exposed, live electrical parts and connections to avoid sparking or arcing. These events could ignite fumes or vapors. Always stop the engine and allow it to cool before filling the fuel tank. Never remove the cap of the fuel ...
- Page 5 wire, and keep the wire away from the plug to prevent accidental starting. Have your machine serviced by a qualified repa r personnel using only identica l replacement parts. This will ensure that the safety of the machine maintained. 1.2 SPECIFIC SAFETY RULES To avoid injury, keep hands, fingers and feet away from the base plate.
-
Page 6: The Product
1.3 SYMBOLS Read these instructions for use carefully. Wear eye protection. Wear hearing protection. Wear protective gloves. Wear safety footwear. It is forbidden to remove or tamper with the protection devices and safety devices. Keep away from rotating parts. Do not touch parts which are hot from operation. Serious burns may result. Do not smoke or have open flames. - Page 7 The commitment to quality has been designed into details: reinforced self-cleaning base plate, engine oil drain hose, closed V-belt guard, self-adjusting centrifugal clutch and folding handle. A range of useful accessories enables use in all kinds of applications. The Plate Compactor applies energy to the loose soil or other materials to increase its density and load bearing capacity, mainly used for small repair and maintenance work.
-
Page 8: Assembly
2.2 SPECIFICATIONS Model HCOMP100-2 Plate Size 410 X 280 mm Impact Force 1030kg Rotary Speed 5300/min Compaction Depth 10 cm Travel Speed 20-25 m/min Engine 1.1kW max1.2kW, 3600/min Operation Weight 34kg Sound pressure level at the operator’s stations 88.5 dB(A), K=3 dB(A),... -
Page 9: Inspection & Operation
4. INSPECTION & OPERATION THE MACHINE IS BEST SUITED TO THE COMPACTION OF BITUMINOUS AND GRANULAR MATERIAL E.G. GRANULAR SOILS, GRAVELS AND SANDS OR MIXTURES OF BOTH , COHESIVE SOILS SUCH AS SILT AND CLAY ARE BEST COMPACTED USING THE IMPACT FORCE PRODUCED BY A VIBRATING RAMMER. WHERE POSSIBLE THE SITE SHOULD BE GRADED AND LEVELLED BEFORE COMMENCING COMPACTION. - Page 10 4.1 INSPECTION Before Starting 1. Road safety instructions: the beginning of manual Clean the compacts, removing dirt and dust. Particularly, the bottom of the plate, engine cooling air inlet, carburetor and air cleaner. 3. Check the air filter for dirt and dust. If the air filter is dirty, blow through the air filter cartridge from the inside, moving a jet of dry compressed air up and down until all dust is removed.
- Page 11 3. Insert and remove the dipstick without screwing it into the filter neck. Check the oil level shown on the dipstick. 4. If the oil level is low (Figure 4), fill to the edge of the oil filter hole with the recommended oil type (Table 3). Maximum oil capacity is 300cc.
- Page 12 Figure 7. V-Belt Tension 3. A loose V-belt will decrease the power transmission output, causing reduced compaction and premature wear of the belt. 4. If the V-belt becomes worn or loose, replace it by using V- belt part number RPF-3320 or A-32. 4.2 OPERATION Before operating the engine for the first time, please review the IMPORTANT SAFETY INFORMATION and chapter titled BEFORE OPERATION.
-
Page 13: Maintenance
WARNING Carbon monoxide gas is toxic. Breathing it can cause unconsciousness and even kill you. Avoid any areas or actions that expose you to carbon monoxide. 4. Turn the engine switch to the ON position. 5. Operate the starter. Pull the starter grip lightly until you feel resistance, then pull briskly. Return the starter grip gently. - Page 14 Air Filter 1. The air filter element should be cleaned because a clogged air cleaner can cause poor engine starting, lack of power and shorten engine life substantially. 2. To clean or replace air filter loosen the wing nut on the air filter housing (Figure 15), remove the cover and takeout air filter cartridge.
-
Page 15: Storage
6. STORAGE If the plate compactor will not be used for a period longer than 30 days, following the steps below to prepare your unit for storage. 1) Drain the fuel tank completely. Stored fuel containing ethanol or MTBE can start to go stale in 30 days. Stale fuel has high gum content and can clog the carburetor and restrict fuel flow. -
Page 16: Troubleshooting
The unit must be transported in the upright position to prevent fuel from spilling. Do not lay machine on its side or top. Secure or tie down unit using the lifting handle to prevent machine from sliding or tipping over. Machine may fall and cause damage or injury if lifted incorrectly. -
Page 17: Declaration Of Conformity
32, rue Aristide Bergès - ZI 31270 Cugnaux – France declare that the machine Designation: VIBRATORY PLATE Model: HCOMP100-2 Serial number: 20230516792-20230516991 The person is responsible for the technical file in EU: Olivier Patriarca Is in conformity with the European Directives:... -
Page 18: Warranty
10. WARRANTY WARRANTY The manufacturer guarantees the product against defects in material and workmanship for a period of 2 years from the date of the original purchase. The warranty only applies if the product is for household use. The warranty does not cover breakdowns due to normal wear and tear. The manufacturer agrees to replace parts identified as defective by the designated distributor. -
Page 19: Product Failure
11. PRODUCT FAILURE WHAT TO DO IF MY MACHINE BREAKS DOWN? If you bought your product in a store: a) Empty the fuel tank if your product has one. b) Make sure that your machine is complete with all accessories supplied, and clean! If this is not the case, the repairer will refuse the machine. -
Page 20: Warranty Exclusions
12. WARRANTY EXCLUSIONS THE WARRANTY DOES NOT COVER: • Start-up and setting up of the product. • Damage resulting from normal wear and tear of the product. • Damage resulting from improper use of the product. • Damage resulting from assembly or start-up not in accordance with the user manual. •...