Page 1
ORIGINAL INSTRUCTIONS VIBRATORY PLATE COMPACTOR HCOMP100-1 INSTRUCTIONS MANUAL Warning: read the manual before use the tool HYUNDAI 32, rue Aristide Bergès - ZI 31270 Cugnaux – France Licensed by Hyundai Corporation, Korea Made in China...
1. SAFETY INSTRUCTIONS General safety rules a) Understanding your machine Read and understand the operator's manual and labels attached to the machine. Learn about its application and limitations as well as its specific potential hazards. Become familiar with the controls and their own operations. Know how to stop the machine and quickly disengage the controls.
Page 4
When filling or emptying the fuel tank, use an approved fuel storage container and do so outdoors in a well-ventilated area. Do not smoke, spark, and leave naked flames or other sources of ignition nearby by adding fuel or operating the unit. Never fill the fuel tank indoors. ...
Page 5
Observe the laws and regulations for proper disposal for gasoline, oil, etc. to protect the environment. Store the machine out of reach of children, and do not leave anyone without experience with the machine or instructions for use. The machine is dangerous for untrained users. f) Review Before cleaning, repairing, inspecting or adjusting the machine, turn off the engine and make sure that moving parts are at a standstill.
Page 6
toxic gases, ground conditions (under the feet). Take special precautionary measures to eliminate or reduce the hazard as described in this manual. SYMBOLS Read instruction handbook Wear hearing and ocular protection Wear protection gloves Wear antiskid shoes of protection It is forbidden to remove or modify the protection and safety devices. Stay away from rotating parts.
Keep children and onlookers out of the way Guarantee sound power level Warning decal Crushing hazard Cutting hazards 2. THE PRODUCT Your new vibrating plate compactor will exceed your expectations. It has been manufactured according to binding quality standards for superior performance criteria. You will find it easy and safe to use, and by maintaining it well, it will give you many years of reliable service.
Page 8
The plate compactor applies energy to loose soil and other materials to increase density and lift, and is generally used for minor repairs and maintenance work. Soft soil or particles are moved or rearranged in a particular manner close to one another to avoid air pockets and voids. It increases lift, decreases water absorption, prevents soil compaction, reduces swelling and soil contraction, and prevents frost damage.
Technical data Model HCOMP100-1 Size of the plate 410 X 280 mm Centrifugal force 10.3kN Speed of the vibrator 5300/min Depth of compaction 10 cm Movement speed 0-20 m/min Engine 1.35kW Weight of operation 34kg Sound pressure level 88.5 dB(A), K=3 dB(A),...
Engine oil OIL WAS DRAINED FOR SHIPMENT Failure to fill the engine crankcase with oil before starting the engine will result in permanent damage and void the engine warranty. Add oil according to the engine manual. 4. INSPECTION & OPERATION THE MACHINE IS BETTER APPROPRIATE TO COMPACTION OF BITUMEN AND GRANULAR MATERIALS LIKE GRANULAR SOILS, GRAVEL AND SAND, OR MIXING BOTH, COHERENT SOILS LIKE LIMON AND CLAY ARE BETTER COMPACT WITH IMPACT...
Page 11
THE VIBRATION MOVEMENT PROVIDES A SELF-PROPULSION ACTION. POSITION THE HANDLE OF THE OPPOSITE SIDE OF THE MACHINE TO THE VIBRATOR START THE ENGINE WITH THE WINDING STARTER. (IF THE MOTOR HAS AN ON / OFF SWITCH, IT MUST FIRST BE SWITCHED ON BEFORE STARTING). FOR MORE INFORMATION ON STARTING AND PROCEDURES CORRECTLY TO OPERATE THE ENGINE, SEE THE OPERATING MANUAL OF THE ENGINE SUPPLIED WITH THE UNIT.
Page 12
FUEL TAP SUCTION LEVER ENGINE STOPPER STARTER AIR FILTER ACCELERATOR HANDLE OF THE STARTER FUEL CAP FUEL TANK SPARK PLUG MUFFLER OIL CAP DRAINING HOLE NOTE Before starting level warning system will 1. Road safety instructions: beginning of the automatically stop the engine before the manual.
Page 13
inside by moving the jet of compressed air up and Season Temperature Type down until all dust is removed. If not, replace the air Summer 25° C or more SAE 10W-30 filter with a new one. Spring 10° C à 25° C SAE 10W-30/20 4.
Page 14
causing a reduction in compaction and premature Clutch pulley wear of the belt. 4. If the belt is worn or loose, replace it with a series belt RPF-3320 or 1-32. Vibrator pulley Figure 6. Danger of the belt 1. To check the belt tension, remove the three bolts securing the belt cover to the body as shown in Figure 7.
START Stop STARTER HANDLE 3. Move the throttle from SLOW, about 1/3 to the 6. Gradually move to the OPEN position when the FAST position. engine starts to heat up. SLOW SPEED FAST SPEED START ACCELERATOR STOP 5. MAINTENANCE ATTENTION : Engine base Oil cap NEVER try to check the belt while the engine...
filter housing (Figure 15), remove the cover and remove the filter If compactor vibrations become weak or cartridge. If only cleaning the air filter is desired, blow through even disappear during normal operations the filter cartridge from the inside by moving the jet of regardless of operating hours, check the belt compressed air up and down until all dust is removed.
Remove the spark plug and drain all oil from the cylinder before attempting to start the unit after storage. 1) Use clean rags on the outside of the compactor, and keep the vents in obstruction. Do not use strong detergents or gasoline-based cleaners to clean plastic parts.
The unit must be transported upright to avoid spilling fuel. Do not lie down or turn over the machine. Secure or attach the unit with the lift handle to prevent the machine from slipping or tipping over. When transporting, towing in a vehicle, secure the machine securely and keep it level to avoid spilling fuel, do not put it down and do not put anything on the machine The machine may fall and cause damage or injury if improperly lifted.
Declaration of conformity EC HYUNDAI 32, rue Aristide Bergès - ZI 31270 Cugnaux – France Declare that the machine VIBRATORY PLATE COMPACTOR Model: HCOMP100-1 Serial number: Responsible of technical file: Olivier Patriarca Is in conformity with the following Directives: Directive Machine 2006/42/EC Directive noise 2000/14/EC Annex VI &...