Table of Contents
Advertisement
5.5 Pseudo power-on debug function
Use the following procedure to use the pseudo power-on debug function. Refer to "5.6 Power-on and
shutdown sequence" for details on the power-on and off sequence.
■ Sequence for using the pseudo power-on debug function
[Starting debugging]
1. Follow the power-on sequence to turn on the power to the emulator, pseudo power-on debug
adapter, and user system.
2. Configure the various settings in the emulator debugger
3. Run the "GO" command on the emulator
[Pseudo power-on debugging]
The pseudo power-on debug function can be operated by simply turning off and on the user power
supply, and power-on debugging can be performed by the emulator.
[Stopping debugging]
1. Perform the emulator reset command (resets the evaluation MCU)
2. Follow the shutdown sequence to turn off the power to the user system, pseudo power-on debug
adapter, and emulator.
Note : If the power supply of the user system is turned off, the MCU does not reset because the user reset is
masked by the emulator. The MCU output pins therefore all maintain the same output state, and there
is a risk that the user system will be damaged. To prevent this, reset the MCU using the emulator reset
command before turning off the power.
10
Advertisement
Table of Contents
