Table of Contents
Advertisement
Bump Test via DC
Apply gas from a cylinder to the sensors manually through the calibration cap, and using the
Device Configurator (DC) app on a mobile device.
1.
Turn On the BW Icon. Place the cap over the detector, and then press down on both tabs
to snap it into place. Wait a few minutes to sensors warm up.
2. Attach the hose.
3.
In your mobile device, open the Device Configurator app
BW Icon
Shop for Gas products online at:
CanarySense
www.
23
.com
User Manual
1.888.610.7664
Advertisement
Table of Contents
