Table of Contents
Advertisement
4. Log in to SSDC with an authorized user account. For further information, refer to the SSDC
User Manual.
5. Click the Device List View tab, the SSDC scans for connected devices, or you can click
Refresh to browse manually.
6. Select the connected detector and then click Start Bump/Cal.
7. In the Start Bump/Calibration Test window, do the following:
Select Bump
l
Select the bump test sensor. You can modify the default values
l
Click START TEST
l
8. Optional Step. You can either remove or keep the IR link connection. The remaining
operation is in the instrument.
9. Apply span gas when the slot LEDs start flashing. The bump test starts after the instrument
detects gas. The four slots LEDs flash blue clockwise. After the bump test is completed, the
LEDs are solid green if calibration passed, or red if failed.
10. Remove the calibration cap. The detector starts purging, and the slots LEDs flash in yellow
clockwise. After the purge is complete, the device is back to the regular mode.
BW Icon
Shop for Gas products online at:
CanarySense
www.
22
.com
User Manual
1.888.610.7664
Advertisement
Table of Contents
