Advertisement
Your filter basket is now dosed with the correct
amount of coffee for your Breville
machine.
If using the Razor™ with a non Breville
espresso machine, you will need to adjust the
depth of the trimmed coffee by trial and error
until you achieve approximately a 1mm gap
between the group head dispersion screen and
the surface of the trimmed coffee. Start with a
dose that is too high, i.e. the dispersion screen
leaves an imprint on the surface of the trimmed
coffee when inserted and removed from the
group head WITHOUT extracting. Adjust
the height of the dose in small steps until you
achieve this clearance. You will then have the
correct dose height for your espresso machine.
Adjust grind size only until you get the right
rate of espresso flow, while keeping the Razor™
dose height and tamp pressure consistent.
Step 5:
Select Your Grind Size
For espresso, we recommend starting with
grind size setting 10 and rotating the Hopper
(to adjust the Grind Size Collar) either
coarser or finer until your preferred flavour
profile is achieved. This should be done in
conjunction with setting the grind amount
(dose).
Refer to the Coffee Chart for approximate
grind size guide.
You will need to extract a shot of espresso
to determine if a change in grind size
and/or grind amount is necessary to achieve
the correct rate of flow. Traditionally, a
single shot of espresso is defined as ~ 30mls
in 30 seconds and a double shot of espresso
as ~ 60mls in 30 seconds.
espresso
®
®
If the Grind Size Collar is tight, run the
grinder by pressing the START | C ANCEL
button while turning the Hopper. This will
release coffee grounds caught between
the burrs.
GRINDING INTO A GRINDS
CONTAINER OR COFFEE FILTER
Step 1:
Remove cradle by sliding out from under the
grind outlet.
Place your container or coffee filter directly
under grind outlet.
NOTE
PULL
11
Advertisement
