Braking; Stopping, Parking - KTM 300 EXC Owner's Manual

9 RIDING INSTRUCTIONS
– Always open the throttle only as much as the engine can handle – abrupt throttle opening increases fuel con-
sumption.
–
To shift down, apply the brakes and close the throttle at the same time.
–
Pull the clutch lever and shift into a lower gear, release the clutch lever slowly, and either open the throttle or
shift again.
–
Switch off the engine if running at idle speed or stationary for a long time.
Guideline
≥ 2 min
–
Avoid frequent and longer slipping of the clutch. This causes the gear oil, engine and cooling system to heat
up.
–
Ride at a low engine speed instead of at a high engine speed with a slipping clutch.
9.5
–
On sandy, wet or slippery surfaces, use the rear brake.
–
Braking should always be completed before you go into a bend. Change down to a lower gear appropriate to
your road speed.
9.6
Note
Material damage The vehicle may be damaged by incorrect procedure when parking.
Significant damage may be caused if the vehicle rolls away or falls over.
The components for parking the vehicle are designed only for the weight of the vehicle.
42

Braking

Warning
Danger of accidents Excessively forceful application of the brakes blocks the wheels.
–
Adjust application of the brakes to the respective riding situation and riding surface conditions.
Warning
Danger of accidents A spongy pressure point on the front or rear brake reduces braking efficiency.
–
Check the brake system and do not continue riding until the problem is eliminated. (Your authorized
KTM workshop will be glad to help.)
Warning
Danger of accidents Moisture and dirt impair the brake system.
–
Brake carefully several times to dry out and remove dirt from the brake linings and the brake discs.

Stopping, parking

Warning
Risk of misappropriation People who act without authorization endanger themselves and others.
–
Do not leave the vehicle unattended if the engine is running.
–
Protect the vehicle against access by unauthorized persons.
Warning
Danger of burns Some vehicle components become very hot when the vehicle is operated.
–
Do not touch any parts such as the exhaust system, radiator, engine, shock absorber, or brake system
before the vehicle parts have cooled down.
–
Let the vehicle parts cool down before you perform any work on the vehicle.