Running In The Engine; Preparing The Vehicle For Difficult Operating Conditions - KTM 300 EXC Owner's Manual

–
Adjust the basic position of the foot brake lever.
–
Adjust the basic position of the shift lever.
–
Get used to handling the motorcycle on a suitable surface before undertaking a more challenging trip.
Info
When offroad, it is recommended that you are accompanied by another person on another vehicle so
that you can help each other.
–
Try also to ride as slowly as possible and in a standing position to get a better feel for the motorcycle.
–
Do not make any off-road trips that exceed your ability and experience.
–
Hold the handlebar firmly with both hands and keep your feet on the footrests when riding.
–
If you carry luggage, make sure you secure it firmly as close as possible to the center of the vehicle and
ensure even weight distribution between the front and rear wheels.
Info
Motorcycles react sensitively to any changes of weight distribution.
–
The maximum permissible overall weight and the maximum permissible axle loads must not be exceeded.
Guideline
Maximum permissible overall weight
Maximum permissible front axle load
Maximum permissible rear axle load
–
Check the spoke tension. (
Info
The spoke tension must be checked after half an hour of operation.
–
Run in the engine. ( p. 35)
8.2

Running in the engine

–
During the running-in phase, do not exceed the specified engine performance.
Guideline
Maximum engine performance
During the first 3 operating hours
During the first 5 operating hours
–
Avoid fully opening the throttle!
8.3

Preparing the vehicle for difficult operating conditions

Info
Use of the vehicle under difficult conditions, such as on sand or on wet and muddy surfaces, can result in
significantly increased wear of components, such as the drive train, brake system, or suspension compo-
nents. For this reason, it may be necessary to inspect or replace parts before the next scheduled service.
–
Clean the air filter and air filter box.
Info
Check the air filter approx. every 30 minutes.
–
Check the electrical connector for humidity and corrosion and to ensure it is firmly seated.
( p. 90)
( p. 122)
335 kg (739 lb.)
145 kg (320 lb.)
190 kg (419 lb.)
p. 101)
< 70 %
< 100 %
( p. 69)
PREPARING FOR USE 8
35