Fcc Compliance - Zte -J G500 User Manual

Gota digital trunking phone
Table of Contents

Advertisement

averaged over ten grams of tissue. Tests for SAR are conducted using
standard operating positions with the device transmitting at its highest
certified power level in all tested frequency bands. The actual SAR level
of an operating device can be well below the maximum value because
the device is designed to use only the power required to reach the
network. That amount changes depending on a number of factors such
as how close you are to a network base station.
The highest SAR value when tested according to international testing
procedures recommended by International Guidelines for Exposure to
Radio Waves (ICNIRP) for use is 0.71 W/kg.
SAR values may vary depending on national reporting and testing
requirements and the network band. Use of device accessories and
enhancements may result in different SAR values.
Notes:
The SAR limit of 2W/kg averaged over ten grams of tissue is the
permitted level of RF energy for the general population. The standards
and guidelines include a substantial safety margin designed to assure the
safety of the public, regardless of age and health and to account for any
variations in measurements.

FCC Compliance

● This device complies with part 15 of the FCC rules. Operation is
subject to the condition that this device does not cause harmful
interference.
● This device has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
9

Advertisement

Table of Contents
loading

Table of Contents