How To Setup A Continuous Controller - Peavey TubeFex Operation Manual

HOW TO SETUPA CONTIAIUOUS CONTROLLER
For this example let's walk through the steps required to create a "wah wah" effect using a continuous
controller pedal. Assuming you have a continuous pedal hooked up to the Tube Fex via a MIDI foot controller,
(EF)
first select or write a patch that has the envelope filter effect and store it. Then push the Edit button,
select EF and push the Edit button again. Next, push the Global button until the following screen is displayed:
TP LP
Move the cursor under RC and use the V and buttons to select channel For this example we will assume
A 1.
your foot controller has channel 7 as a continuous channel send. Next push the Global button until the
following screen is displayed:
Move the cursor under Pram and use the 7 and buttons to select Freq. Next move the cursor under C#
A
Ch RCV.
and select Next move the cursor under and select Next move the cursor under S and
C
select It is impor&nt to note that the scale can be set from HO0 allowing normal or reverse wah wall
effects. You can set the scale anywhere in between to adjust the effect to your tastes. Next press the Edit button
Sn Fq
and move the cursor under and select a sensitivity level. Try +48 to start. Next move the cursor under
Rs
and select a frequency, try 50. Next move the cursor under and set the resonance, try 52. Next move the
cursor under Ty to select a filter, try Next move the cursor under Mx and try a mix level of 50%. Now
work the continuous controller pedal to try the effect. Adjust the envelope filter parameters and the scale to
suit your taste. Press the Store button to save the settings and continuous controller to your preset.
Note: If you get volume control instead of wah wah, push the Global button until the following screen is
displayed:
OFF.
Move the cursor under and change the setting to Now try your effect. can also use the 4-band
parametric EQ to create this effect.
Chapter 4 Using MIDI
26