Loading Sets Or Presets To Their Original Locations; Loading Sets Or Presets To New Locations; Remote Editing Using Midi System Exclusive - Peavey TubeFex Operation Manual

To dump a set of presets to an external device (or another Tube Fex): In the MIDI menu display press the
or left arrow button until the cursor is under
dump. The display will briefly show:
Note: The MIDI transmit channel of the Tube Fex must be set the same as the MID1 receive channel on the
external device unless the external device is set to OMNT.
To load sets or presets to their original locations from an external storage device or another Tube Fex,
set the MTDT receive channel to match the MIDI send channel on the external storage device (or other
Tube Fex). Then send the set or presets to the Tube Fex. That's all there is to it!
Note: See the owners manual of the storage device for instructions on sending MIDI dumps.
To load sets or presets to a new location. Set the MIDI receive channel to match the MI111 send channel on
the external storage device or Tube Fex. Then select
LS (Load
or Set) if loading a set to a new location. Select the new location. Then send the preset or set to
the Tube Fex.
Note: The MIDI receive channel of the Tube Fex must be the same as the channel the data was
transmitted on. An error message will appear if they are not the same. If this occurs, set the receive
channel to the channel shown in the message :: ~1 transmit again.
A set of special system exclusive editing commands is available on the Tube Fjex. This will allow remote
programming of all effect parameters, effect levels, the effect chain, and continuous controller assignments.
The edit buffer can also be stored in any user preset location remotely. These changes can t>c heard
immediately, but will not appear on the screen unless the parameter being edited is currently selected. SW
Appendix B for complete remote editing command information for programmers of rem( w ect iting devices
Chapter 4 Using MIDI
DS (Dump Set).
(O-12) to be dumped. Press the Store/Exec button to execute the
LP (Load Preset) if loading a preset to a new location