Advertisement
3. Single Coil Mode Select - A row of three solder pads is used to select the active coil
in Single Coil / Voice-3 mode
The active coil is selected by a solder bridge connecting the corresponding outer pad
to the center one.
The pickups ship from the factory with the neck side coils set as the default. To change
the active coils to the bridge ones, remove the solder bridge and create a new one
from the other outer pad to the center. To avoid damaging the pads, solder wick or a
desoldering pump are strongly recommended for removing the solder bridge.
4. SCO Bridge Pickup (South Coil Out) - This solder pad is used to conveniently ac-
cess the south coil. This is used as an input for the neck NCO (North Coil Out) signal in
position-2 of 5-way switch wiring. It can also function as an output for HSH (Humbucker,
Single, Humbucker) and HSS pickup combinations using the Fluence SSA Single width.
8
Advertisement
