Rear View - Panasonic WR-XS3 Operating Instructions Manual

!0 I nput peak indicator [INPUT PEAK]
Lights up when any input signal reaches –3 dB (from
the MONO INPUT 1 to 4 connectors, the STEREO
INPUT 1 to 4 jacks , the MULTI INPUT ST connectors,
the MULTI INPUT MONO connector and the LINE IN
jack) above the clip level.
!1 Output level knobs
[STEREO OUT]
Turning to the left will lower the stereo output level.
Turning to the right will raise the output level.

Rear View

q w
ON
OFF
OFF
ST 1
MODE A B 4 3 2 1 4 3 2 1
1
STEREO MONO
2
INPUT SELECT
3
MODE SUB
SELECT OUTPUT +4dB 10k
e r
q DIP switches
Switches A and B select the unit mode from among
mode 1, 2 and 3.
Switches MONO 1 to 4 and STEREO 1 to 4 assign any
input lines to SUB OUTPUT jack.
Refer to pp. 15 to 18.
w Stereo input auto mute switch [ST 1- 4 AUTO MUTE]
Selects the auto mute setting when an input signal is
accepted via the MONO INPUT connector 1 or 2. Auto
mute is applicable to information broadcasting with
BGM in a shop.
ON (;): The volume(s) of the STEREO INPUT 1 to 4
jacks are automatically muted.
OFF (l): The volume(s) of the STEREO INPUT 1 to 4
jacks are not automatically muted.
Mute level: 9 dB
e Sub output jack [SUB OUTPUT]
Transmits a signal from a desired input line (from
among the STEREO INPUT 1 to 4 jacks, the MONO
INPUT 1 to 4 connectors, or the MULTI INPUT ST jacks)
which is mixed by the unit.
Mono: 1 circuit
Output jack: TRS jack electronic balanced
Output level: +4 dB
Impedance: 10 k
r Mono output jack [MONO OUTPUT]
Transmits a mono signal mixed by the unit.
Mono: 1 circuit
Output jack: TRS jack electronic balanced
9
y u i
PIN CONNECTION
ST
No. 1: GND
ON No. 2: HOT L L
No. 3: COLD
4 AUTO MUTE
R L
R R
–10dBV 10k +4dB 10k –10dBV 10k
MONO STEREO
REC OUT SUB IN MULTI INPUT
t
[MONO OUT]
Turning to the left will lower the mono output level.
Turning to the right will raise the mono output level.
[SUB OUT]
Turning to the left will lower the sub output level.
Turning to the right will raise the output level.
o !0
4 3 2 1
MONO
L
R
–45dB 10k
STEREO INPUT –10dBV 10k MONO INPUT –60dB to –10dB 10k
Output level: +4 dB
Impedance: 10 k
t Stereo output jacks [STEREO OUTPUT L/R]
These jacks transmit a stereo signal mixed by the unit.
Stereo: 1 circuit
Output jack: TRS jack electronic balanced
Output level: +4 dB
Impedance: 10 k
y Recording output jacks [REC OUT L/R]
These jacks connect to a recording device such as a
stereo cassette recorder or MD recorder.
Stereo: 1 circuit
Output jack: RCA type pin jack unbalanced
Output level: –10 dBV
Impedance: 10 k
u Sub input jacks [SUB IN L/R]
These jacks receive output signals from sub mixer, etc.
The signals input to these connectors are output
through the STEREO OUTPUT jack.
Stereo: 1 circuit
Input jack: RCA type pin jack unbalanced
Input level: +4 dB
Impedance: 10 k
i Multiple stereo input jacks [MULTI INPUT ST L/R]
These jacks connect to audio-visual devices such as a
CD player and tape recorder.
Stereo: 1 circuit
Input jack: RCA type pin jack unbalanced
!1 !2
0dB is referenced to 0.775Vrms
4 3 2 1
AC IN
ST 1 4 AUTO MUTE
Ser No.
SIGNAL
GND
!3