Required Tools And Materials; Decommissioning And Disposal - Siemens SIMATIC NET RUGGEDCOM RS900GP Installation Manual

RS-232 Console Port
POWER LED
ALARM LED
Failsafe Alarm Relay
Power Supply Terminal Block
1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RS900GP:
DC power cord (16 AWG)
CAT-5 Ethernet cables
#2 Phillips Flathead screwdriver
Phillips screwdriver
4 x M3.5 (#6-32) screws
1.4

Decommissioning and Disposal

Proper decommissioning and disposal of this device is important to prevent malicious
users from obtaining proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of
service, either permanently or for maintenance by a third-party, make sure it has
been fully decommissioned.
For more information, refer to the associated "Configuration Manual".
Recycling and Disposal
For environmentally friendly recycling and disposal of this device and related
accessories, contact a facility certified to dispose of waste electrical and electronic
RUGGEDCOM RS900GP
Installation Manual, 11/2022, C79000-G8976-1026-09
The serial console port is for interfacing directly with the device
and accessing initial management functions. For information
about connecting to the device via the serial console port, refer to
"Connecting to the Device" (Page
Illuminates when power is being supplied to the device.
Color
Green
Off
Illuminates when an alarm condition exists.
Latches to default state when a power disruption or other alarm
condition occurs. For more information, refer to:
• "Connecting the Failsafe Alarm Relay" (Page 11)
• "Failsafe Alarm Relay Specifications" (Page 23)
A pluggable terminal block. For more information, refer to:
• "Connecting Power" (Page 12)
• "Power Supply Specifications" (Page 23)
Tools/Materials
1.3 Required Tools and Materials
15).
Description
Device is receiving power
No power
Purpose
For connecting power to the device.
For connecting the device to the network.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For mounting the device to a panel.
Introduction
3