Maintenance - Ariens GRAVELY Sno-Thro Owner/Operator & Parts Manual

After operation, position deflector to its highest position
and lock. This is to prevent snow and ice from
accumulating and stopping deflector movement.
Ariens Dealers will provide any service or adjustments
which may be required to keep your unit operating at
peak efficiency. Should engine service be required,
contact an Ariens dealer or an authorized engine
manufacturer's service center.
WARNING: AVOID INJURY. Read and
understand Maintenance and Service Safety
Rules in Safety section before attempting any

maintenance.

MAINTENANCE SCHEDULE
The chart below shows the recommended
maintenance that should be performed on a regular
basis. More frequent service may be required.
MAINTENANCE SCHEDULE
Daily
Service Performed
Check Fasteners
Check Auger
Gearcase Lubrication
General Lubrication
*
First Maintenance Only
SERVICE POSITION
Place unit on a flat level surface. Assure unit is secure
and will not tip over. Strap and clamp onto bench if
needed.
CHECK FASTENERS
Make sure all hardware is tightened properly.
CHECK AUGER GEARCASE
IMPORTANT: Proper oil level must be maintained.
Gear cases are filled to the correct level at the factory.
Unless there is evidence of leakage, no additional
lubricant should be required. Check for evidence of
leakage every 25 hours of operation.
To ensure adequate lubricant level:
1. Remove filler plug (Figure 10). Lubricant must be
at least up to bottom of lubricant filler hole with
unit resting on a level-surface.
MAINTENANCE
Every Every
Yearly
5 hrs. 25 hrs.
•
•
•
2. Add lubricant if required. Allow oil to drain to level
of plug and replace plug.
3. Use only Ariens special gear lubricant L-2 (Part
Number 00008000).
LUBRICATION LOCATIONS
IMPORTANT: Wipe each fitting clean before and after
lubrication.
IMPORTANT: DO NOT allow grease or oil to get on
•
belts.
NOTE: Apply Sten Mix Hi-Temp Grease or equivalent
to the lubrication fittings. Order P/N: 00036800 - Three
Pack of 3 oz. cartridges or 00036700 - 10 pack of 14
oz. cartridges.
Sno-Thro should be lubricated (Figure 11) at beginning
of season or every 25 operating hours. See
Maintenance Schedule.
10
1
1. Auger Gearcase
2. Filler Plug
Figure 10
Figure 11
2
OTt2000
OTt1880