Maintenance - Ariens Power Brush 28 Manual

Ariens Dealers will provide any service or
adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine service be required, contact an Ariens
dealer or an authorized engine
manufacturer's service center.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
SERVICE POSITION
IMPORTANT: DO NOT tip unit up onto brush.
Remove the brush if maintenance requires
tipping the unit forward. Ensure unit is secure
and will not tip over. Strap or clamp unit onto
bench if required.
To access components in the unit frame:
1. Shut off engine and allow unit to cool
completely. Place unit on a flat level
surface.
2. Remove belt cover.
3. Remove hardware attaching remote
trigger cable to brush assembly and
detach cable (Figure 8).
Detach cable here.
4. Remove the six cap screws from the
bottom cover. Remove the bottom cover
before separating unit.
5. Remove cap screws and belt finger
(Figure 9).

MAINTENANCE

Figure 8
1
1. Cap Screws
6. Remove attachment drive belt from
engine sheave (it may be necessary to
turn engine sheave using recoil starter
handle).
7. Support unit frame and brush
attachment.
8. Remove cap screws securing
attachment to unit frame.
9. Remove attachment belt from
attachment pulley.
10. Separate frame from brush.
OSS0269
GB - 15
WARNING: ALWAYS remove key
and/or wire from spark plug before
assembly, maintenance or service.
Unintentional engine start up can
cause death or serious injury.
2. Belt Finger
Figure 9
CAUTION: Always support unit
frame and brush attachment when
loosening the cap screws holding
them together.
2
OSS0269