WARNING: AVOID INJURY. Read and
understand Assembly Safety Rules in Safety
section before proceeding.
Refer to Parts for detailed assembly illustrations.
Tools Required
• 1/4" Drive Socket Set
• Adjustable Wrench
• Hand Hex Driver
Package Contents
Discharge
Chute Assembly
Chute Crank
Assembly
Figure 3
Preparing Tractor for Sno Thro Installation
1. Remove tractor hood.
2. Remove nuts and lock washers securing pillow
blocks.
3. Lower front rockshaft and install left spring arm
stud (Figure 5). Secure stud with locknut.
Reinstall left pillow block.
4. Reinstall right pillow block. Fasten limiting post
underneath block using right pillow block
hardware (Figure 4).
5. Install right spring arm stud on tractor frame and
secure with locknut.
6. Raise hydraulic lift completely. Front rockshaft
arms should be parallel with ground. To adjust,
loosen pillow block mounting bolts and turn
adjustment screw counterclockwise to lift,
clockwise to lower (Figure 4). Retighten pillow
block mounting bolts.
ASSEMBLY
7. Fasten spring arms to both sides of tractor.
8. Secure spring arm latches to both sides of tractor
Sno Thro
Assembly
7
(Figure 5).
1
5
2
3
1
6
1. Pillow Block
2. Adjustment Screw
3. Mounting Bolts
Figure 4
10
8
9
11
6
2
7
1. Spring Arm Stud
2. Spring Arm
3. Hex Bolt
4. Spacer
5. Spring Arm Latch
6. Washer 5/16"
Figure 5
4
4. Front Rockshaft
5. Limiting Post
6. Limiting Arm
1
3
3
4
5
6
7
OTt0370
7. Lock Nut 5/16-18
8. Hairpin Cotter
9. Lock Nut 1/2-13
10. Washer
11. Brace