Maintenance Schedule - Ariens Lawn Edger Manual

Owners manual
Table of Contents

Advertisement

WARNING: AVOID INJURY.
Read and understand the entire
Safety section before
proceeding.
Interval
Check Safety
Interlock System
Clean Unit
Check Tires
Each
Use
Check Edger Blade
and Mounting
Hardware
Check Guards and
Mounting Hardware
Check Engine Oil
Level
Check Engine Air
Filter
Lubrication
25 Hours
or Every
Season
Check Belt
50 Hours
or Every
Check Spindle
Season
Bearings

MAINTENANCE SCHEDULE

Task
Remove all dirt, grease, leaves, etc.
Make sure the tires are positioned correctly for the
intended job and are securely fastened. See Make sure
the front wheel does not contact the blade when angling
the blade for a beveled edge. on page 10 and Front Wheel
Adjuster on page 10.
Make sure the blade is free of nicks, broken ends, thinned
metal or other damage. Make sure the hardware is
tightened to 30 – 62 lbf-ft. (40.7 – 84.0 N•m). See Blade
Change on page 15.
Make sure all guards are securely fastened and are in
good repair.
Check the engine oil level according to instructions
provided in the engine owner's manual.
Check the engine air filter for dirt and debris according to
instructions provided in the engine owner's manual. Clean
or replace as needed.
Apply a light oil to the pivot shaft and all sliding joints, to
the front axle shaft and to the wheel bushings.
Change engine oil according to instruction provided in the
engine owner's manual.
Check the belt for cuts, nicks or abrasions. Replace worn
or damaged belts. See Belt Change on page 15.
Check the spindle bearings for wear or damage. Replace
as needed.
IMPORTANT: Proper maintenance can
prolong the life of unit. The following chart
shows the recommended service schedule.
Refer to the maintenance instructions in the
Engine Manual for additional information.
Action
WARNING: Safety interlock system failure and
improper operation of unit can result in death or
serious injury. Test this system each time the unit
is operated. If this system does not function as
described, do not operate until repairs are made.
See Operator Presence Control on page 9.
GB - 14

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

986101986103

Table of Contents