Table of Contents
Advertisement
3.3
Programming the VoIP Gateway Card in the
Chicago Office
This section details the procedure to program the VoIP Gateway Card in the Chicago office, which for
the most part is a duplication of that for the Los Angeles office. For general information that is not
discussed here, refer to the relevant sections in "3.2 Programming the VoIP Gateway Card in the Los
Angeles Office".
There are differences in the procedure where distinct setting values are required for parameters that
are dependent on the specific network configuration of the Chicago office. Also, the address
translation table does not need to be programmed, because the one downloaded from the card in the
Los Angeles office already contains the information for the entire network. You can simply upload the
address translation table from the Los Angeles office, and the cards can communicate with each
other on the network.
Starting the IP-GW16 Maintenance Utility
Changing the Status of the VoIP Gateway Card
3.3 Programming the VoIP Gateway Card in the Chicago Office
1. Start Internet Explorer from the Start menu.
2.
a.
In the Address box of Internet Explorer, type
http://192.168.1.200 (default IP address of the
card).
Make sure that the PC has the appropriate IP
address setting to access the card (refer to
"3.1.1 Preparing the PC").
b.
Press the ENTER key on the keyboard.
3.
a.
In the Username box, type Administrator
(default user name).
b.
In the Password box, type Administrator
(default password).
c.
Click LOGIN.
The main menu appears.
1. Click 2.1 Change RUN/STOP status in the main
menu.
2.
a.
Click STOP for Status after changing.
b.
Click OK.
c.
Click OK.
d.
Click OK.
Getting Started
37
Advertisement
Table of Contents
