Canon Finisher-AK1 Service Manual page 336

7) Move the Latch Plate (Rear) in the direction of the arrow and insert it to the pin to fix it.
• 1 Screw (Use the Screw removed in the step 9) of "Before Installing the Finisher")
8) Fix the cable.
• 2 Reuse Bands
• 2 Edge Saddles
x4
Edge Saddle
7
Installation > Installation Procedure > Connecting with the Paper Folding Unit
Latch Plate
Screw
(Rear)
F-7-53
Reuse Band
F-7-54
7 Installation > Installation Procedure > Connecting with the Paper Folding Unit
9) Insert the connector to the Finisher Controller PCB, and fix the cable.
• 2 Wire Saddles
x2
10) Check the height between Finisher and the Paper Folding Unit.
CAUTION:
Height difference should be within +/- 2 mm.
Execute "Height Adjustment" if the difference is +/- 2 mm or more.
Finisher
7-20
Wire Saddles
Connector
F-7-55
Paper Folding Unit
F-7-56
7-20