5
Adjustment > Auxiliary Adjustment > Adjusting Engagement/Disengagement Position of Saddle Disengagement Roller > Procedure
Adjusting Engagement/Disengagement Position of
Saddle Disengagement Roller
Execute this adjustment in the case of significant displacement in stapling
position.
NOTE:
Executing this adjustment enables gap adjustment between the disengagement roller [1]
and the paper, so that this operation improves feeding performance inside the saddle
assembly.
[1]
M102
■ Preparations
1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
5
Adjustment > Auxiliary Adjustment > Adjusting Engagement/Disengagement Position of Saddle Disengagement Roller > Procedure
■ Procedure
1) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
2) Press switch SW385 [1] so that this adjustment is ready now.
F-5-271
[1]
SW382
SW381
SW383
SW384 SW385
(-)
(+)
ENTER
F-5-272
SW382
SW381
SW383
SW384 SW385
(-)
(+)
ENTER
[1]
F-5-273
5-113
5-113