Table of Contents
Advertisement
Operator Cab and Controls - Section 32
Page 32-14
RH Control/Indicator Panel (Pod)
RH control/indicator panel (3, Figure 32-6), located to
the right of the steering wheel, provides an array of
switches and controls. For detailed information on
this assembly, refer to RH Control/Indicator Panel
(Pod) later in this section.
Center Display Panel
Center display panel (4, Figure 32-6) provides an
array of gauges and monitors, with an odometer
module) and a service/hour meter module. For
detailed information on this assembly, refer to Center
Display Panel later in this section.
LH Control/Indicator Panel (Pod)
LH control/indicator panel (5, Figure 32-6), located to
the left of the steering wheel, provides an array of
indicator/monitor lights and three switches. For
detailed information on this assembly, refer to LH
Control/Indicator Panel (Pod) later in this section.
Ladder Light Switch
Ladder light switch (6, Figure 32-
6) turns the ladder lights on or off
after or before using the ladder. A
similar switch is available at
ground level to turn the ladder
lights on or off.
Head Light Switch
The
instrument
clearance lights, and the head-
lights are controlled by this three
position rocker type switch (7,
Figure 32-6). OFF is selected by
pressing the left side of the
switch. Press the right side of the
switch until it reaches the first
detent (middle) to select the panel, clearance, and
tail lights, only. Press the right side of the switch
again, until it reaches the second detent to select the
headlights, as well as panel, clearance, and tail
lights.
OFF
BackUp/Deck Light Switch
RH Control/Indicator Panel (Pod)
RH control/indicator panel (3, Figure 32-6), located to
the right of the steering wheel, contains the following:
Cold Weather Starting Aid (Ether Injection)
Switch
switch and hold for 2-3 seconds before starting the
engine. The cold starting aid atomizes ether into the
engine intake manifold.
Refer to Keyswitch - START for further details
regarding the use of this switch.
panel
lights,
DO NOT push the ether injection switch after the
engine has started! SERIOUS DAMAGE TO THE
ENGINE MAY OCCUR!
These are rocker type switches.
The OFF and ON positions are
marked with these symbols.
Backup/deck light switch (8, Fig-
ure 32-6) allows backup lights to
be turned on providing added
visibility and safety when the
transmission range selector lever
(see Operator Controls) is not in
the REVERSE position.
Starting aid switch (1, Figure 32-7) is
an ON/OFF type rocker switch that is
spring-loaded to the OFF position.
When the outside temperature is below
-5°C (23°F), depress the top of this
08/11 OM3211
ON
Advertisement
Table of Contents
