Table of Contents
Advertisement
OM2032 03/13
Fire Prevention
•
Thoroughly
remove
chips, leaves, paper and other
flammable items accumulated
in the engine compartment.
Failure to do so could result in
a fire.
•
Check fuel, lubrication, and hydraulic systems for
leaks. Repair any leaks. Clean any excess oil,
fuel or other flammable fluids, and dispose of
properly.
•
Ensure a fire extinguisher is present and in
proper working condition.
•
DO NOT operate the machine near open flames.
Preparing For Operation
•
Always mount and dismount while facing the
truck. Never attempt to mount or dismount the
truck while it is in motion. Always use handrails
and ladders when mounting or dismounting the
truck.
•
Check the deck areas for debris, loose hardware,
and tools.
•
Check for people and objects that might be in the
area. Remove any obstructions and wait for any
personnel in the area to disperse.
•
Become familiar with and use all protective
equipment devices on the truck and ensure that
these items (anti-skid material, grab bars, seat
belts, etc.) are securely in place.
Ventilation In Enclosed Areas
•
If it is necessary to start the
engine within an enclosed
area,
provide
adequate
ventilation.
Exhaust
from the engine can kill.
wood
fumes
In Operator's Cab - Before Starting The Engine
•
DO NOT leave tools or spare parts lying around
or allow trash to accumulate in the cab of the
truck. Keep all unauthorized reading material out
of the truck cab.
•
Keep the cab floor, controls, steps, and handrails
free of oil, grease, snow, and excess dirt.
•
Check the seat belt, buckle and hardware for
damage or wear. Replace any worn or damaged
parts. Always use the seat belts when operating
a machine.
•
Read and understand the contents of this manual
pertaining to safety and operating instructions
with
special
attention.
acquainted with all gauges, instruments and
controls before attempting operation of the truck.
•
Read and understand the warning and caution
decals in the operator's cab.
•
Ensure the steering wheel, horn, controls and
pedals are free of any oil, grease or mud.
•
Check
operation
of
condition of wiper blades, and check the washer
fluid reservoir level.
•
Be familiar with all steering and brake system
controls, warning devices, road speeds and
loading capabilities, before operating the truck.
Mirrors, Windows, And Lights
•
Remove any dirt from the surface of the
windshield, cab windows, mirrors and lights.
Good visibility may prevent an accident.
•
Adjust rear view mirrors to a position where the
operator can see best from the operator's seat.
•
If any glass or light should break, replace it with a
new part.
•
Ensure headlights, work lights and taillights are in
proper working order. Ensure that the machine is
equipped with the proper work lamps needed for
the operating conditions.
Safety - Section 20
Page 20-5
Become
thoroughly
the
windshield
wiper,
Advertisement
Table of Contents
