Table of Contents
Advertisement
OM4041 08/11
Prior to each operating shift, a "walk around" inspection should be performed. Check the truck for general condi-
tion. Look for evidence of hydraulic leaks; check all lights and mirrors for clean and unbroken lenses; check opera-
tor's cab for clean and unbroken glass; check frame, sheet metal and body for cracks. Notify the proper
maintenance authority if any discrepancies are found. Give particular attention to the following:
Truck Serial Number______________________
Hourmeter_____________
1. CHECK ALL FLUID LEVELS
a. Engine Oil-
NOTE: Refer to engine manufacturer service manual
for oil recommendations.
b. Radiator - Check coolant level and fill with the
proper mixture as recommended in Coolant
Specifications.
c. Batteries - Check electrolyte level and add
water if necessary.
d. Hydraulic Tank - Check oil level in tank, add if
necessary. Lube key "C". Refer to Hydraulic
Tank Service, in this chapter.
NOTE: Check the oil level with the truck on a level
surface, engine stopped, body down, and oil warm.
Oil should be visible in sight glass. - Do Not overfill.
e. Transmission - Check oil level. Add oil if nec-
essary. Lube key "C".
Refer to Transmission Oil Level Check in this
chapter.
f. Fuel Tank - Fill as required.
g. Differential - The truck should be on a level
surface, and the oil level should be even with
plug hole. Refill with oil, as necessary. Lube
key "B".
2 CHECK MACHINE FOR LEAKS
Inspect all fluid components and piping for signs of
leakage.
10 HOUR (DAILY) INSPECTION
Site Unit Number_______________
Name of Service Technician___________________________________
TASK
Lubrication and Service - Section 40
Date_______________
COMMENTS
CHECKED INITIALS
Page 40-3
Advertisement
Table of Contents
