Installation
Attaching the wire
[Convertible camera AW-E350/E650/E655/E750/E860
The camera comes with a wire for preventing the camera from dropping. Follow the instructions below to use it to couple the
camera to the pan-tilt head.
When mounting the cameras with fan (AW-E655, AW-E750, AW-E860)
Use the wire mounting screw (M48 mm with flat washer and spring washer) to attach one end of the wire to the pan-tilt
head's arm.
Mount the mounting spacer on the top panel of the camera. (The mounting spacer is provided with the camera as an accessory.)
Use the wire mounting screw (M48 mm with flat washer and spring washer) to attach the other end of the wire to the screw
hole of the mounting spacer.
When mounting the cameras without fan (AW-E350, AW-E650)
Use the wire mounting screw (M48 mm with flat washer and spring washer) to attach one end of the wire to the pan-tilt
head's arm.
Use the wire mounting screw (M48 mm with flat washer and spring washer) to attach the other end of the wire to the screw
hole of the top panel of the camera.
For a stand-alone installation
Camera: AW-E750
M48 mm wire
Wire
mounting screw
with flat washer
and spring
washer
Mounting spacer
( supplied with
M48 mm wire
AW-E750)
mounting screw
with flat washer
and spring washer
Camera: AW-E350, AW-E650
Be absolutely sure to tighten up the mounting spacer and screws securely using a tool such as a screwdriver.
]
Arm
For installation on the ceiling
Camera: AW-E750
Camera: AW-E350, AW-E650
19
M48 mm wire
mounting screw
with flat washer and
spring washer
M48 mm
wire mounting
screw with flat
washer and
spring washer
Mounting spacer
( supplied with
AW-E750)