Pan-Tilt Head Mounting Conditions; Installing The Pan-Tilt Head - Panasonic AW-PH405N Operating Instructions Manual

Installation
 Pan-tilt head mounting conditions
Pan-tilt Mounting
head weight specifications
Stand-alone
Approx.  lbs installation or
(10 kg) installation on
the celling
Mounting the pan-tilt head
Recommended screws
M6 screws (hexagonal nuts)
Notes
 Refer to the above table for the total weight of the pan-tilt head with the camera, lens, cables and any
other accessories installed.
Install the equipment on an installation surface which is capable of ensuring a drop safety equivalent to
five times the figure for the total weight.
 The maximum weight of the units which can be installed on the pan-tilt head is .1 lbs (15 kg) or so
[or approximately 55.1 lbs (5 kg) total for the weight of the pan-tilt head and weight of the units
installed on the head]. When mounting the pan-tilt head on which units have been installed, be sure to
mount it on an installation surface which is itself capable of ensuring a satisfactory drop safety.
 Installing the pan-tilt head
Before installing the pan-tilt head, check that the above mounting conditions are satisfied, and observe the following precautions.
In order to prevent accidents resulting when the product becomes dislodged or falls down, be absolutely sure to proceed as
instructed. Do not install the pan-tilt head on its side since its prescribed operation and performance cannot be ensured.
 After the pan-tilt head has been installed, mount the camera on it.
 When installing the pan-tilt head, use the four mounting holes to secure the pan-tilt head firmly.
 Ensure that the surface on which the pan-tilt head will be installed and the anchor bolts used are sufficiently strong.
 Use the M6 hexagon head bolts (including one short bolt) for installation.
 Use hexagon head bolts which are longer than the thickness (t) of the mounted member + 1" (5 mm).
 As shown in the figure of next page, use flat washers, spring washers and hexagon nuts for the hexagon head bolts.
 Use a wrench of the appropriate size to tighten up the hexagon head bolts.
 Provide a wire which is strong enough to support the combined weight of the entire pan-tilt head system (which consists of the
pan-tilt head, camera, lens and cable).
 Do not use a surface made of plaster board or wood as this kind of installation surface will not be strong enough. If mounting
on such a surface is unavoidable, take sufficient anti-drop measures.
 Install the pan-tilt head in such a way that the equipment and cable attached to it will not make contact with any surrounding
objects when the head is swiveled.
 When the unit is no longer going to be used, do not leave it in place, and be absolutely sure to remove it.
Compatible Camera
cameras weight
Convertible
camera series
Approx.
AW-E50
.6 lbs
AW-E650
(1. kg)
AW-E655
max.
AW-E750
AW-E860
Multi-purpose Approx.
camera series . lbs
AK-HC1500G (1.5 kg)
No. of screws
4 pcs
Camera
Compatible
anti-drop
lenses
measures
AW-LZ16MD55P
AW-LZ16MD7P
AW-LZ17MD9AG
Wire provided
used for
mounting
HA1 series
HA series
HJ17e series
HJ1e series
16
Cable
Lens weight Total weight
weight
Approx. .9 lbs
(1. kg) max.
Approx.
0.7 lbs
(0. kg)
Approx. 7.1 lbs
(. kg) max.
Approx.
8.7 lbs
(1 kg)
Approx.
.1 lbs
(15 kg)